Overburden (muri) is one of the three evils of manufacturing, along with unevenness (mura) and waste (muda). Out of the three, overburden is probably the least understood. Hence, in this post I will look deeper at overburden, including plenty of examples as well as the effects of overburden on your people.
mura
Reducing Fluctuations Downstream
This last post of my series looks at fluctuations that originate downstream from your location. In other words, how to reduce fluctuations originating from your customer. Granted, this often is the most difficult one, as you usually have not so much influence over your customers (unless you have a monopoly). Let’s have a look.
Reducing Fluctuations on Your Shop Floor
Fluctuations can also originate within your area of responsibility. In my previous post, I looked at how to reduce fluctuations coming from upstream. In this post I look at your shop floor. Using the source-make-deliver structure, this post is about reducing fluctuations at “make.”
Reducing Fluctuations Upstream
This post will list a number of tools that can help to reduce fluctuations. They can reduce fluctuations in the material flow, including its inventories and the durations and lead times. Since reducing fluctuations (mura) is an underlying important idea throughout lean manufacturing, a lot of tools can help. And, depending on how you interpret tools, this list is not even complete.
Structure for Reducing Fluctuations
This post looks at how to reduce fluctuations (mura) in manufacturing. It is a continuation of the previous post that looked at why fluctuations are so bad. Be warned, tackling fluctuations is often a tedious task that never ends, but it one of the important fundamentals for lean manufacturing. After all, the more stable a system runs, the more efficient it is. Leveling is one major method to reduce fluctuations that focuses on the production schedule. Line balancing is another one that focuses on the work content.
Why Are Fluctuations So Bad?
Fluctuations are bad for manufacturing. In lean, unevenness is one of the three evils, besides waste and overburden. In this post I will give you an introduction to fluctuations. One option to handle fluctuations is decoupling, but this addresses only the symptoms and not the cure. In my next post I will show you how to actually reduce fluctuations.